Panasonic KX-T2386BA - Manual (Page 11)

Prior to Leaving
ANSWERING & RECORDING
&
ANS SYS
. To turn on the power (power light on)
Push
•The Answer/Call indicator will light after 10 seconds.
MESSAGE MEMO
Push
Speak into
Micro­
phone
Push
MEMO
to finish
Automatic Answering
and Recording
One touch on the Answer System
On/Off Switch enables the unit to
answer calls.
•When the telephone rings, the unit wilt
play the outgoing message, then it will
record the caller’s message.
•The Answer/Call indicator will flash
and show the number of recorded
incoming messages. Although, the
flashing is limited up to 15 times in a
group, more messages can be
recorded.
•In case of a power failure, the Answer/
Call indicator will flash slowly after the
power is restored.
If you do not want to set the unit to the
Answer mode, turn the Answer
System On/Off Switch off.
Message Memo
To record a confidential message, any
time at home, on the iCM part of the tape
to be heard by someone using the unit.
1
Confirm that the Answer indicator
lights or flashes.
2
Push the Memo Button until a
beep sounds, followed by a
series of short beeps then a long
beep will be heard.
3
Speak for up to 150 seconds.
4
Push the Memo Button, when
you finish.
•The unit will be ready to answer the
next call.
To Monitor Calls
Adjust the Volume Control.
To Speak Directly
Lift the handset while answering (or
recording) calls.
•The tape will stop moving.
• If you lift another handset connected to
the KX-T2386BA, the tape will not stop.
- 1 0 -