Panasonic KX-T1470BA - Manual (Page 36)

Troubleshooting Guide
Problem Cause
&
Remedy
•The unit does not work when 1 press any
buttons.
^•1 cannot remove the cassette from the unit.
N
Plug In the AC adaptor then switch
the power on.
J
^he unit has been set to the Answer mode,
but no Incoming Messages are recorded.
1
_________________________________________________
•The greeting message or ICM
cassette is cut or is not inserted.
Replace the cassette with a new one.
•The greeting message is recorded
improperly.
Record a new greeting message.
•The recording time selector is set to
“ANNOUNCE". .
"^The unit does not function. However, 6 beeps
sound and the Call-Counter shows “Err”.
V_______ ^_____ __________________
•Greeting message cassette might ^
be broken.
•Clean the heads. (See page 36.)
'^Whiie recording a greeting message, 6 beep
sounds are heard.
V________________ _________________
A
• Re-record a greeting message. Speak
clearly and loudly, and do not pause
for over 2 seconds while recording.
J
^When the greeting message or the ICM tape
is played back, the sound level is low, even if
the VOLUME control is turned up fully.
Clean the Heads. (See Maintenance ^
instruction on page 36.)
J
have played back alt the recorded
messages and 1 want to record the next
phone call after the last previously recorded
message.
•Wait for 7 seconds. The unit will be ^
ready to record the next phone call.
•In case of remote operation, just
hang up.
press the button of a remote phone, but
the unit does not respond.
L. ... . . •
•Make sure that you are entering your^
correct Code number.
• Record a greeting message in a
quiet place. ^
—
Some ICM have not been recorded up to
their end.
V_____________
Set the CPC switch to “B". ^
(See page 7.)
J
1 The ICM tape continues to run after a caller
^ ‘angs up.
Set the recording time selector to
“1 MIN”. (See page 7.)
-
34
-