Setting, Scsi id number and terminator setting, Id number – Panasonic Portable CD-Rom Player KXL-810A User Manual
Page 36: Terminator
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SCSI ID Number and Terminator Setting
■ ses/
ID number:
Each SCSI device connected to your computer can be assigned an individual ID number
{refer to the respective manuals). Be sure that the player’s SCSI ID number is not same as
another SCSI device connected to the computer.
The factory setting of the player’s SCSI ID number is set to 5.
■
Terminator:
The factory setting is OFF.
ON: • When the supplied interface card is used to connect to Zip or Jaz drive.
• When the desktop computer is connected with a SCSI board (not supplied)
{(^ P. 16). If SCSI devices are connected, set their terminators to OFF.
OFF: • When the supplied interface card is used to connect to a computer (sgÿ- P. 14).
(power from the computer can be used).
• When using independently as an audio CD player (os^ P. 18) with the alkaline
batteries or rechargeable battery installed (power consumption can be saved).
Setting
Make sure that the player is off.
Set the SCSI ID number switch (1—3) or Terminator switch (4) ON/OFF by using a pointed
object like a pen (do not use a pencil), and referring to the table below (for SCSI ID
number).
(For SCSI ID number setting)
Example: SCSI ID number=5
Terminator=OFF
SCSI ID
number
SCSI ID number
switch
1
2
3
0
OFF
OFF
OFF
1
ON
OFF
OFF
2
OFF
ON
OFF
3
ON
ON
OFF
4
OFF
OFF
ON
5
ON
OFF
ON
6
OFF
ON
ON
7*
ON
ON
ON
36
I
I: Factory setting
* Do not use “7” for player’s SCSI ID
number, since it is used for the
interface card or SCSI board.