Dynon Avionics EFIS-D10 Users Guide - Manual (Page 26)

5/25/2005 22
DIM – Changing screen
brightness
From main menu 2, press the DIM button, which causes the
brightness control submenu to appear. Pressing BRITR will
increase screen brightness until it reaches its maximum. Pressing DRKR will decrease screen brightness until it reaches
its minimum. It is not possible to turn the screen completely black via this menu to prevent confusion between a dimmed
state and a turned-off state.
TIMER – Setting and using a
timer
To access the timer, navigate to Main Menu 2, and press the
TIMER button. This will take you to the Timer menu seen
in the diagram.
In the value setting box, you will see either UP TIMER or
DN TIMER with the current timer value below. The
following points will assist you as you work with the timer.
•
The UP/DN button toggles the menu and timer
between an up timer and a down timer. When
switching to an up timer, the timer set value resets,
allowing the up timer to count up from 0:00:00.
•
To reset the timer, press the UP/DN button twice. This will bring you back to the same state (i.e. UP or DOWN
TIMER) that you were in before.