Dynon Avionics EFIS-D10 Users Guide - Manual (Page 22)

5/25/2005 18
only the hours for the local time. Be aware that connecting to the EFIS-D10 with the Support Program will reset the
time; therefore, do not set the time until you have performed all of the PC interface operations. To set the time, simply
follow these guidelines:
•
Set both the local and Zulu times in military time. This is to eliminate confusion during the clock setting process.
You have the option, as described below in the Clock Format section, to display the time in either military or
standard 12-hour format.
•
Only the highlighted digits will be affected by increments or decrements.
•
SEL moves the highlight to the next set of digits. The order of selection is 1. Local hours, 2. Local minutes, 3. Zulu
hours. When Zulu hours are selected, pressing SEL will again highlight Local hours.
•
DEC and INC decrement and increment the selected set of digits one at a time. To speed up the process, press and
hold the desired button. if you pass the desired value, you may simply back down to it by pressing the button
corresponding to the opposite direction.
•
Incrementing or decrementing the minutes digits resets the second count, allowing you to set the clock down to the
second if you so desire.
Change clock format
Although you always set the clock in military time, you have the option to display it in either military or standard time.
Additionally, if you desire, you may display either local or Zulu time in the lower right corner of the screen. To set these
options, press the FORMAT button from the CLOCK submenu. This will display the FORMAT submenu as seen in the
picture above. In this submenu, you toggle between local and Zulu time display by pressing either button 1 or button 2.
The status text following the colon shows the current status of the LOC/ZU toggle. To toggle between standard and
military time display, press either button 3 or button 4. Again, the status text following the colon shows the current status
of the 12/24 toggle.