DVR systems DVRxx04LE-S(U) Series - Manual (Page 36)

36
Important
If the HDD amount is less than four, you do not need to install the HDD bracket.
When there is a bracket, please make sure the installation direction of HDDs is the same.
3.3.2 4 HDD Series
This series DVR max supports 4 SATA HDDs. Please use HDD of 7200rpm or higher. It has no
requirement for HDD capacity.
You can refer to the appendix for recommended HDD brand.
Please follow the instructions below to install hard disk.
After completing HDD installation, please check connection of data ribbon and power cord.
3.4 Rack Installation
7. Unfasten the HDD power
cable.
9. Use the special data cable to
connect the HDD and the SATA
port. Close the chassis and fix
the screws to secure firmly.
8. Insert the HDD power
cable.
1. Loosen the screws of the
upper cover.
2. Line up the HDD to the four
holes of the HDD bracket.
3. Use four screws to fix HDD.
4. Unfasten the HDD power
cable.
5. Use the special data cable to
connect the HDD and the SATA
port
6. Insert the HDD power cable.
Close the chassis and fix the
screws to secure firmly.