DVR systems DVRxx04LE-A Series - Manual (Page 65)

65
The UPNP protocol is to establish a mapping relationship between the LAN and the WAN.
Please input the router IP address in the LAN in Figure 5-9. Double click the UPNP item in Figure
5-9, you can see the following interface. See Figure 5-16.
z
UPNP on/off ：Turn on or off the UPNP function of the device.
z Status: When the UPNP is offline, it shows as “Unknown”. When the UPNP works it shows
“Success”
z Router LAN IP: It is the router IP in the LAN.
z WAN IP: It is the router IP in the WAN.
z Port Mapping list： The port mapping list here is the one to one relationship with the router’s
port mapping setting.
z Enable Switch : ：It shows that the function of port mapping is enabled in this port.
z List：
— Service name：Defined by user.
— Protocol： Protocol type
— Internal port：Port that has been mapped in the router.
— External port：Port that has been mapped locally.
z Default: UPNP default port setting is the HTTP, TCP and UDP of the DVR.
z Add to the list: Click it to add the mapping relationship.
z Delete: Click it to remove one mapping item.
Double click one item; you can change the corresponding mapping information. See Figure 5-17.
Important:
When you are setting the router external port, please use 1024~5000 port. Do not use well-
known port 1~255 and the system port 256~1023 to avoid conflict.
For the TCP and UDP, please make sure the internal port and external port are the same to
guarantee the proper data transmission.
Figure 5-16