CANOGA PERKINS 9145 NID - Manual (Page 2)

Canoga Perkins Corporation, 20600 Prairie Street, Chatsworth, CA 91311-6008
Phone: (818) 718-6300, FAX (818) 718-6312 www.canoga.com
P/N 6943300 Rev A Page 2 of 8
Figure 2. Optical module insertion in the EXT port
Step 3: Rackmount Installation
To mount the 9145 in a rack, carefully remove the four rubber feet located under the NID using a
small, flat screwdriver. Install the rack mount ears using the screws provided in the kit onto the
9145 chassis. Screw in three on each side of the NID using a Phillip’s head screw driver as
shown in Figure 3.
Figure 3. Rackmount ear installed
When mounting the unit in a rack, be sure to accommodate at least 1RU, 1.75”, of space in the
rack due to the height of the NID. See Figure 4.
Figure 4. 9145 installed in a rack