CANOGA PERKINS 9145E Ethernet Network Interface Device Hardware - Manual (Page 39)

Operation 9145E Ethernet Network Interface Device User’s Manual
Power-Up and Front Panel Functions
27
4.1 Power-Up and Front Panel Functions
The LEDs on the front panel indicate the system and port status of the 9145E (see Figure 4-1).
During power-up, all LEDs on the 9145E will light amber. When power-up has been completed,
the LEDs will display status as described in the following paragraphs. Additional information
about fault conditions appears in the System Alarms and System Status & Configuration screens
(Reference 6913601, 9145E NID Software User’s Manual).
Figure 4-1. 9145E Status Indicators
4.1.1 Power and Status LEDs
The power (PWR) and status (STA) LEDs, located to the right of the console port (see Figure 4-
1), indicate condition and state of the 9145E. See Table 4-1 for significance of LED conditions.
4.1.1 Ethernet Management LEDS
The Link/Activity (LNK/ACT) front panel LED, located to the right of the MGMT UTP Port (see
Figure 4-1), indicates the presence of transmit or receive activity. The Speed (SPD) front panel
LED, located directly below the LINK/ACT LED, indicates the speed of the transmissions. See
Table 4-1 to determine the 9145E status.
CONSOLE PORT
POWER LED
STATUS LED
LINK / ACTIVITY LED (TYP)
SPEED LED (TYP)
MGMT UTP PORT
Chapter 4
Operation