BendixKing SILVER CROWN PLUS System SILVER CROWN PLUS - Manual (Page 30)

Silver Crown Plus Pilot’s Guide
26
and the channel’s corresponding
frequency in the “STBY” window.
3. If there is no activity for five
seconds, the radio will exit the
Channel Mode and return to the
Frequency Mode, with the channel
frequency remaining in the “STBY”
window.
4. You can also return to the
Frequency Mode by either:
a. Pressing the channel button before
the five-second delay, in which case
the radio recalls the “USE” and
“STBY” frequencies prior to entering
the Channel Mode, or
b. Pressing the transfer button, so that
the channel frequency becomes the
active frequency and the last “USE”
frequency becomes the new “STBY”
frequency.
NOTE: If the optional remote channel
increment switch is installed, each
activation of the switch will put the unit
in the Channel Mode and advance the
channel number from the previous
channel used.
Direct Tune Mode
The Direct Tune Mode is entered
by pressing and holding the transfer
button for longer than two seconds.
The “STBY” frequency will disappear
and the frequency in the active
window can be changed with the
frequency selection knobs.
Momentarily pushing the transfer
button will return the unit to the
Frequency Mode (normal operation).
The “STBY” frequency displayed prior
to entering the Direct Tune Mode will
return unchanged.
Default Mode
Turning on your KY 196A, KY
197A or KY 196B while pressing the
transfer button will bring the unit up in
the Direct Tune Mode and install
120.00MHz or 120.000MHz (KY
196B) as the active frequency. This
will aid the pilot in blind tuning the
radio in the unlikely event of display
failure.
Display Adjust Modes
To enter the Display Adjust
Mode, press and hold the channel
button until the Program Mode is
entered. Continue holding the channel
button while simultaneously pressing
and holding the frequency transfer
button until “dA 1” replaces the
frequency in the “USE” window.