BendixKing KLN 900 - Abbreviated Guide - Manual (Page 55)

The second is to electronically update the database by means of 3.5”
diskettes supplied by Honeywell and a laptop computer. This method
does not involve removing the KLN 900 from the aircraft’s instrument
panel. A data port on the front of KLN 900 provides a means of inter-
facing the unit with the computer via an interface cable. The diskettes are
not returned to Honeywell. This method of update is for use anywhere in
the world that diskettes may be shipped. Directions for updating the data-
base using a laptop computer are contained in section 2.4.1 of the KLN
900 Pilot’s Guide.
In order to utilize the first method of database update, exchange the KLN
900 PCMCIA card. Follow these steps to update the KLN 900 database
by removing the old card and inserting the new card:
• Remove the old database card by pulling it straight out the front of the
KLN 900.
• Remove the new database card from its shipping container. Note that
the label on the card indicates which side is up and which end to insert
into the KLN 900. Insert the new card into the front of the unit.
• The container which was used to ship the new card to you is used to
return the old card back to Honeywell. A return shipping label is
included in the container. Remove the backing from the label and place
it in the address position of the shipping container.
• Insert the old card into the container. Peel off the protective backing
from the adhesive on the end flap on the container. Press the flap
against the adhesive to seal the container.
• Please return the old card promptly by mailing immediately at any
mailbox. No postage is required if mailed from within the U.S. Users
will be billed for cards not returned, and no additional cards will be sent
until either the old card or payment for the old card is received.
51