BendixKing KXP 756 - Manual (Page 40)

39
Program Operation
The program mode is accessed
by depressing the PGM switch.
The program mode must be
entered while in the channel
configuration (only channels can be
programmed). Once in the program
mode, the channel number, emission
mode and transmit frequency are
displayed. Transmit is inhibited. The
transmit frequency however, may be
examined by depressing the mic key.
Note: LSB only available where
application permits.
The following information is
stored during the program operation:
A. Receiver frequency
B. Transmit frequency
C. Receive only channel logic
D. LSB, AME, USB, A3A logic
To set a receive only frequency
on any given channel, perform the
following:
A. Depress the PGM switch.
B. Select channel to be set to receive
only.
C. Set receive frequency.
D. Select receive mode (LSB, AME,
USB, A3A).
E. Depress STO switch once.
F. Release the PGM switch or select
and program the next channel as
desired.
The above procedure stores the
displayed frequency, stores the
displayed receive frequency and sets
the receive only bit.
The “TX” message will flash after
the STO actuation to indicate that the
transmit frequency will be stored on
the next STO actuation.
Setting a simplex channel would
require the following steps:
A. Depress the PGM switch.
B. Select channel to be set to
simplex.
C. Set receive/transmit frequency.
D. Select emission mode (LSB, AME,
USB, A3A).
E. Depress STO switch twice.
F. Release the PGM switch or select
and program the next channel as
desired.
Setting a semi-duplex channel
would require the following steps:
A. Depress the PGM switch.
B. Select channel to be set to semi-
duplex.
C. Set receive frequency.
D. Select emission mode (LSB, AME,
USB, A3A)
E. Depress STO switch once.
F. Set transmit frequency.
G. Depress STO switch.
H. Release the PGM switch or select
and program the next channel as
desired.