BendixKing KXP 756 - Manual (Page 33)

32
Program Mode
A. Program mode is selected by
pressing and holding the CHAN
button for longer than 2 seconds. The
unit remains tuned to the last Active
frequency displayed before entering
Program mode and the last used
channel number is displayed. The
channel number flashes. Either
Frequency Control knob changes the
channel number. Any channel, 1 thru
9, may be programmed. When the
channel number is flashing, pressing
the Transfer button will cause the
channel number to stop flashing and
cause the frequency to flash. The
Frequency Control knobs work as in
Frequency mode. When frequency is
flashing, pressing the Transfer button
will cause the frequency to stop
flashing and the channel number to
flash allowing the next channel to be
programmed. An unprogrammed
channel displays dashes.
B. In frequency rollover or
rollunder, dashes will be displayed
before rolling to the highest or lowest
frequency respectively. Leaving the
dashes in the display unprograms the
channel when leaving Program mode.
C. If no knob activity has occur-
red for 20 seconds the unit returns to
Frequency mode. The unit can also
be returned to Frequency mode from
Program mode by pressing the CHAN
button. Returning to Frequency mode
will not change the Active or Standby
frequency from what it was prior to
entering Program mode.
D. The On/Off/Volume and
Mode controls operate as in
Frequency mode.
Default Mode
Turning the unit on while holding
the Transfer button down will bring the
unit on in Active Entry and load
800KHz as the Active frequency.
Military Operation
Channel Mode
A. Momentarily pressing the
CHAN button while in Frequency
mode puts the unit in Channel mode.
The last channel used is the channel
number displayed. The unit tunes the
ADF receiver to the frequency in the
Standby display provided that it is a
valid frequency. Otherwise it will tune
the KDF 806 to the last Active
frequency. If no channels are
programmed the unit will display for 3
seconds; “CH 1” and dashes in the
Standby window. Turning either
Frequency Control knob changes the
channel number and corresponding
channel frequency. The unit will only
channel to channel numbers with a
valid frequency programmed. If the
frequency is below 190Khz, the ADF
receiver does not operate and the
frequency flashes.
Holding Transfer Button for 2
seconds selects Active Entry.
NOTE: Channel mode does not time
out as in civil operation.
B. Momentarily pressing the
CHAN button will return the unit to
frequency mode and the status
remains what it was prior to entering
Channel mode. The KDF 806 will be
tuned to the frequency in the Active
display.
C. The On/Off/Volume and Mode
controls operate as in Frequency
mode.
Program Mode
A. Pressing and holding the
CHAN button for longer than 2
seconds brings the unit into Program
mode. The last used channel number
is displayed and flashes. The ADF
receiver remains tuned to the last