BendixKing KXP 756 - Manual (Page 10)

9
Military Operation
Channel Mode
Momentarily pressing the CHAN
button while in the Frequency mode
places the unit in the Channel mode.
The last channel used will be the
Channel number displayed. The
receiver will be tuned to the frequency
displayed in the Standby window. If
no channels are programmed into the
unit, the unit will display “CH 1” and
dashes in the Standby display for 5
seconds and will tune the receiver to
the last Active frequency. The unit will
only channel to channel numbers with
a frequency programmed into them.
Note: Channel mode does not time
out as in civil operation.
Momentarily pressing the CHAN
button will return the unit to the
Frequency mode and the status will
remain as it was prior to entering the
Channel mode. Holding the Transfer
button depressed for more than 2
seconds while in the Channel mode
will cause the unit to enter the Active
Tune mode.
Program Mode
Pressing and holding the CHAN
button for longer than 2 seconds will
cause the unit to enter the Program
mode. The last channel in use will be
displayed and will be flashing. The
receiver will be tuned to the last Active
frequency. While flashing, the
Channel number may be changed
with the Frequency Control knobs.
Pressing the Transfer button will
cause the Channel number to stop
flashing and the frequency in the
Standby window will flash. The
frequency may then be changed with
the Frequency Control knobs in the
manner described above. The first
step past either band edge will cause
dashes to be displayed in the Standby
window. Any Channel with dashes
entered will be unprogrammed. An
unprogrammed Channel will display
dashes in the Standby window when
recalled, in which case the receiver
will be tuned to the last valid Active
frequency.
Pressing the CHAN button will
return the unit to the mode in use prior
to entering the Program mode. The
receiver will be tuned to the frequency
displayed in the Active window if it
returns to the Frequency mode or will
be tuned to the frequency displayed in
the Standby window if it returns to the
Channel mode.
Default Mode
Turning the unit on while holding
the Transfer button down will bring the
unit on in the Active Entry mode and
display 110.00 as the Active
frequency. This will aid the pilot in
blind tuning the unit in case of a
display failure.
Remote Transfer
Operates identically to the front
panel Transfer button with the
exception that holding the Remote
Transfer button for 2 seconds does not
cause the unit to enter the Active Entry
mode.
Remote Channel
Pressing the Remote Channel
button will cause the system to enter
the Channel mode of operation and
will increment the channel from the
previous channel number used.