Beckett 61687 GeniSys Display and Contractor Tool - Manual (Page 6)

6


►
NEXT

Cycle End Reason*
* The possible cycle end reasons are
as follows,
Recycled - The burner was shut
down because the fl ame was lost.
Pump Prime - The burner cycle was
terminated due to a manual pump
prime override.
Manual Shutdown - The Reset
button was held to shut down the
burner.
Low Voltage - The burner shut
down because the line voltage to the
burner dropped too low.
CFH Ended - The burner cycle
ended because there was no longer
a call for heat.
Replace Control - This indicates
that the control detected an internal
failure.
Did Not Light - The cad cell did not
sense fl ame at the end of the trial for
ignition (lockout) time.
Lost Flame - The burner was shut
down because of excessive recycling.
Pre-time Flame - A fl ame was
detected at the end of the Pre-time
(valve-on-delay).
►
NEXT




SEL
(YES)


To display the various readings
associated with a single burner cycle,
press the NEXT or PREV keys. For
example, to display the time required to
light the burner, the cad cell maximum
and average resistance, the average
line voltage, the cycle end reason,
and the time the burner remained off.
►
NEXT


►
NEXT


►
NEXT


►
NEXT
8.