Kidde KN-COB-DP-LS - Manual (Page 12)

When you first power up the alarm: The red Alarm LED will light and
the alarm will sound briefly, then the green Operate LED will light. This
indicates that the CO alarm is receiving power and that the alarm circuit
is functioning.
How to Install Your Alarm
Direct Plug Alarm
To install:
1. Choose a standard 120V unswitched outlet to
plug the alarm into.
2. If outlet is mounted sideways (horizontally), rotate
the plug and plug the alarm in.
CAUTION: Do not rotate the alarm while it is
plugged into an outlet, as damage to plug may
result.
Important Labels Provided
Two labels have been provided that have important information on what
to do in case of an alarm. Add the phone number of your emergency
service provider in the space provided. Place one label next to the alarm
after it is mounted, and one label near a fresh air source such as a door
or window.
4. Installation Instructions
90º ROTATING DIRECT
PLUG
5. Alarm Characteristics
Carbon Monoxide Alarm Indicator
When the alarm senses a dangerous level of CO, the unit will emit a
loud alarm pattern. The alarm pattern is 4 quick beeps followed by 5
seconds of silence. This cycle repeats as long as a dangerous CO condi-
tions exist. The red Alarm LED will flash the same pattern (and the PPM
will be displayed on alarms with digital displays).
WARNING: When powered by battery backup only; after four min-
utes, the alarm will sound and flash only once every minute, until the
alarm is reset or the CO is eliminated.
If the unit is unplugged it will produce a constant tone until the battery
is removed or the unit is plugged back into the wall, if the Tamper-Resist
feature has been activated.
WARNING: If at any time you test the alarm and it does not per-
form as described, have it replaced immediately.
6. KN-COB-DP-LS Operating Characteristics
!
!
2526-7206-00(820-1371 Rev. C).qxd:_ 2012.11.5 2:22 PM