Sangean ATS-909X w (V1) User Manual

Page 29

Note:

When the buzzer alarm activates, the alarm will start softly and

gradually increase in level. It will sound for 1 minute and silence

for 1 minute in repetition for 30 minutes unless cancelled.

The radio will sound non-stop at the selected time for up to

60 minutes for other radio alarm types.

To set radio for an alarm timer, first press one of the TIMER

buttons and (SSB) / RDS / Alarm MODE button until Radio Alarm

icon flashes on the display. Then set up the alarm time

(hours and minutes) by using the numerical keys on the key pad

and Enter Selection button. When the sounds beep it means the

alarm has been activated.

Then tune to the station you would like to be awaken to. Press the

Memo button and then press the TIMER button number. When the

sounds beep it means the alarm has been activated. Your radio will

automatically switch on at the setup time.

In addition to being able to set 3 different wake up times it is

possible to set each wake up time to a different frequency.

To view the setting of an active timer, press the required

TIMER button. The timer number and the alarm time or the

radio alarm frequency can be viewed flashing in the LCD display.

The active alarm may be stopped by pressing the

STANDBY/SLEEP button. To permanently disable the alarm,

press the required TIMER button number followed by the

Cancel button. Then the timer number will disappear on

the display.