Changing batteries – Sangean ATS-909X w (V1) User Manual

Page 13

CHANGING BATTERIES

Press and remove battery cover in the direction indicated by the

arrow on the cover. Insert 4xUM-3 (AA Size) batteries with

polarities exactly as shown on diagram inside the

battery compartment. Slide battery cover back into place in

direction of arrow until case snaps into place.

Each time the ATS-909X is turned on the battery level indicator will

remain. Batteries should be replaced when battery level drops or

the level indicator flashes.

Batteries must be replaced within 3 minutes to retain

clock display. (Input memory will remain intact even during power

failure because receiver is equipped with EEPROM memory)

Note:

If you use non-rechargeable batteries, before inserting the

batteries make sure the Alkaline (Batteries) or NIMH/NICAD

(Charger) switch (which is located inside the battery

compartment) is switched to the Alkaline (Batteries) position. If you

use rechargeable batteries, make sure to switch NIMH/NICAD/

Alkaline switch to the NIMH/NICAD (Charger) position.

Note:

You may make sure to have the same capacity of the

rechargeable batteries, and then they can be balanced

to full charge.