Sangean ATS-909X w (V1) - Manual (Page 25)

To move a station, in memory to another position recall station.
Press Memo button, MEMO and position display will flash,
press new position desired and a signal will be heard indicating the
exchange has taken place and the positions have been swapped.
EXCHANGING STATION POSITIONS IN MEMORY
To select an SW Band, press METER/SW button once and then
press a second time. A flashing m will appear in the display.
Any of the 14 SW bands (11-120m) can now be selected using
the numerical keys on the key pad. The band selected appears in
the LCD display and will remain in the display as long as tuning
activity remains within the metered band.
To start Auto Scan Tuning, select an SW band to tune, press one
of the Tuning Up/Down buttons for more than 0.5 second.
Once scan starts, release the button. The Auto Scan stops as
soon as an SW station of adequate signal strength is located.
Repeat operation to start scan again. Scan can be halted by
pressing the Tuning Up/Down buttons momentarily any time
during the scanning process. The range scan for SW station is
being circulated as a loop within the meter band unless you
continue pressing the one of the Tuning Up/Down buttons till the
frequency across out of the meter band range.
To manually tune to a frequency of your choice repeatedly,
press and release one of the Tuning Up/Down buttons until the
frequency desired is displayed.
SELECTING AN SW BAND
24 25
GB