Sangean ATS-909X w (V1) User Manual

Page 23

To Manually Set Memory on SW Band:

Tune to station you would like to program into memory.

Press Memo button, MEMO will flash in the LCD display.

Select page desired by using the PAGE button and Rotary

Tuning Knob. Display will flash and next available position on

display will flash if an available position is available. Press Enter

Selection button to assign frequency to flashing available position.

If memory is full no suggested position will flash and LCD will

display MEMO FULL when any button is depressed. If selected

button is held for more than 2 seconds, even with MEMO

FULL flashing. Newly selected station will replace existing station.

You may change or initiate any page name at any time by first

selecting the page and then pressing the EDIT button and using

the Rotary Tuning Knob to place an alphanumeric character in the

name space in the LCD Display. Once a character is selected you

may move to the next position to place another character by

using the Tuning Up/Down button. When name is completely

entered press Enter Selection button.

Note:

You may change and edit your SW band’s pages names, but there

is no FM/MW/LW page name. You may change and edit your

FM/MW/LW bands’ preset names, but there is no any SW

preset name.

Note:

Every memory preset memory can be stored including

its frequency, mode (AM/LSB/USB), and fine tuning frequency.