Manual- rear panel hook-up inputs, Power, Effects loops – Rane TTM 56 User Manual
Page 4: Send/return cable wiring, Ttm 56

Manual-
Rear Panel Hook-up
Inputs
PGM 1
and PGM 2 each have stereo PHONO and stereo LINE inputs.
PHONO 1
and PHONO 2 inputs are RIAA compensated inputs, for turntables only!
PHONO GND
terminals provide independent ground connect points for turntables. It is very important that each turntable have a
very good ground connection to one of these terminals. The thumbscrews will come off if they are over-rotated, so be careful not
to spin them off and lose them.
LINE 1
and LINE 2 inputs are unbalanced line-level inputs with a sensitivity of -10 dBV (max gain).
AUX INPUT
may be used with a drum machine, groovebox, sampler, or another mixer’s output for session mix. This Input is mixed
after the Crossfader and Effects loop.
MIC INPUT
is a balanced input specifically designed for a dynamic microphone.
Power
POWER
connector. This is not a telephone jack! Connect only the Rane RS 1 power supply included with your TTM 56.
The POWER switch is located just above the power connector. You know what to do with this one, but leave it off until everything is
connected.
Effects Loops
MIC EFFECTS
insert jack is unbalanced. It is wired for TRS, Tip=Send, Ring=Return. This is an independent Effects Loop for the
Mic. There is no engage switch, so the Mic signal is always processed when you have an effects box connected. If you are connect-
ing to an effects processor with a Send/Return jack, a single TRS cable will work. If your effects processor has separate Send and
Receive jacks, you need a “Y” cable. You can buy a Send/Return cable from your local music store, or you can make one of your
own, as shown below.
FlexFX EFFECTS
jacks are unbalanced mono ¼" TS (Tip/Sleeve). This stereo loop is used for output to (send) and input from (re-
turn) an effects processor. The SEND jacks provide the output to your effects processor. The RETURN jacks provide input for the
signal returning from your effects processor. To use with effects insert devices with a single TRS, tip=send, ring=return jack, you
need a “Y” cable, as shown below.
1-CONDUCTOR SHIELDED CABLE
1-CONDUCTOR SHIELDED CABLE
T
=
SE
N
D
R
=
RE
TU
RN
S
=
SH
IE
LD
+
+
SEND
RETURN
+
+
SHIELD
SHIELD
SHIELD
Send/Return Cable Wiring
TTM 56
FlexFX
MASTER OUT
PHONO
GROUND
EFFECTS
PGM 2
AUX
PGM 1
MIC
UNBALANCED
BALANCED
MADE IN U.S.A.
RANE CORP.
U.S. PATENT
6,813,361
R
L
R
L
R
L
L
R
L
OUT
IN
RETURN
TIP = SEND
RING = RETURN
R
BAL INPUT
LINE 2
SEND
PHONO 2
PHONO 1
LINE 1
ACN 001 345 482
CLASS 2 EQUIPMENT
750mA
POWER