Rane RPM 26i - Manual (Page 9)

Manual-9
This dialog allows you to configure the MRP (Memory
Recall Port) on newer versions of the RPM 26i beginning
with firmware rev 2.2.
Each possible MRP pattern is shown as a decimal number
and binary code where 1 represents a switch closure on the
numbered contact. To its right is a drop-down menu for each
input pattern, where you select the Memory to be recalled.
You can cusomize Memory recall values, save them to a
MRP file and load them into future units.
After exiting this dialog with the OK button, the MRP in
the unit will be updated.
Device > Restore Memories from File
This menu item allows you to restore all Memories and
names to a device from a selected file.
Note: All saved RPM 26i data files are given the default
extension .RPM.
Device > Lock Device
Lock Device allows you to lock a device to prevent
unauthorized users from making changes to your pro-
grammed settings in the device’s Memories. Although a
device is locked, different presets can still be recalled by
selecting another Memory via the Site Control Panel, the
Memory Recall Port, or by clicking on a desired Memory key
on the button bar with the mouse. The data previously stored
in the device’s Memories, however, can not be changed.
To Lock a device, type in the password in the dialog box
shown above after selecting Lock Device from the Device
menu. When a device is locked, this icon appears to
the right of the Local Edit button on the button bar.
Device > Unlock Device
This menu selection restores a device to its unlocked state,
allowing changes to the data previously stored in its Memo-
ries. You must type in the correct password before the device
will unlock and the lock icon disappears.
Device > Edit MRP Configuration