Rane RPE 228 Manual - Manual (Page 5)

Manual-5
SOFTWARE OPERATION
Step by Step Installation
If you have the RaneWare 3.5" floppy disk, insert it in
your drive. In Windows 3.1 Program Manager, under File,
select Run. On the command line, type A:\install. Click
OK. This starts installation. In Windows 95, use Add/
Remove Programs in the Control Panel.
If you downloaded RaneWare from the web, decompress
the file first. Create a new directory named RANEWARE,
and move the RW232***.EXE file to this new directory. Now
run this file, and all the separate files will decompress. Locate
INSTALL.EXE, click OK. Installation now proceeds as file
locations are verified.
Starting RaneWare
A RaneWare program group is now created, containing
RaneWare, the RaneWare Address Calculator, and RaneWare
Help. When the software is first installed, RaneWare Help
appears. Here any questions can get answered. Subsequent
activation does not bring up RaneWare Help until you ask for
it. But let’s get on with the program. Close the Help file, and
welcome to RaneWare!
RANEWARE REQUIREMENTS
• RaneWare 232 works under Microsoft Windows 3.1, 95 or
NT
® on a PC or laptop with an unused serial port.
• RaneWare 232 needs a fully wired DB9 cable less than 50'
long, connecting from the serial port of a computer to the
RPE 228 communications input port. No interface boxes are
required; just a cable and your computer.
• RaneWare 232 can be fully demonstrated and used without
an actual RPE 228 attached.
• A RaneWare 3½" floppy comes with each unit. Installation
is simple and follows standard procedure with both Windows
3.1 and 95. The latest version is downloadable 24 hours a day
from Rane’s Internet web site, http://www.rane.com.