Rane MP 2 2001 version - Manual

Manual-1
OPERATORS MANUAL MP 2
CLUB MIXER
QUICK START
If you are too excited to read the manual, at least read this page to minimize any potential mistakes (we know you don't
make any). Be sure your amplifier is off while making connections, and every time you turn on your system, apply power to
your amplifier last.
The most common assumption is that the cables you already have will work. Well, let's be sure first. None of your RCA
cables should be longer than 10 feet (3 meters) or you are asking for hum. The MAIN and AUX OUTPUTS are balanced
¼" TRS (tip-ring-sleeve) connectors, allowing you to run long lines if neccessary with properly balanced cables. If you
really have to use unbalanced (tip-sleeve) cables, keep them as short as possible (well under 10 feet [or 3 meters]). If you
are connecting balanced devices (3-conductor) to either Input of the MP 2, or are sending the Output to an unbalanced
equalizer or amplifier, consult the included RaneNote “Sound System Interconnection” for proper wiring.
The MP 2 has 3 sets of Outputs. The HOUSE OUTPUT is set by the front panel HOUSE LEVEL control. The AUX
OUTPUT is set by the rear panel screwdriver adjusted AUX LEVEL control. The TAPE OUTPUT is fixed. All Output
level controls are independent of each other. The only Level controls that affect all Outputs simultaneously are the PGM A
and B LEVEL controls.
If you bring a phono signal into P1 or P2 be sure to keep the PHONO switch in; likewise when connecting a CD player
to this input, be sure the PHONO switch is out.
Start with the HOUSE LEVEL all the way down so you don't scare the neighbors. Start with the Crossfader all the way
to the left (PGM A). Select an INPUT for PGM A and another for PGM B and start playing your sources. Set the EQ
controls to the center. Adjust the LEVEL controls so that the bottom three (-24, -12, and 0) indicators light up. If the +12
indicator flashes, turn down the LEVEL control. Now slowly turn up the HOUSE LEVEL so you can hear things working.
Moving the Crossfader to the right brings in the source selected on PGM B.
The headphone cue system is simple: The PAN controls the headphone mix between the Program going to the HOUSE
and what is on CUE, determined by the CUE switches.
Never connect anything except a Rane RS 1 to the thing that looks like a red telephone jack on the rear of the
MP 2. This is an AC supply and requires some special attention if you do not have an operational power supply exactly like
the one that came with your unit. Consult the Rane factory for a replacement or substitution.
WEAR PART
This product contains the following wear part subject to the ninety (90) day warranty period described on page Warranty-1:
(1) Active Crossfader #11646.