Rane DC 22S (2009 version) - Manual (Page 5)

Manual-3
Rear Panel Description
INPUTS 1 and 2: Choose between the balanced XLR or the balanced/unbalanced ¼" TRS jacks, but only use one. Inserting a ¼"
TS jack will work—however—we recommend using balanced lines, especially when connecting any cable over 10 feet (3 meters)
in length. Consult the Sound System Interconnection RaneNote provided with this manual.
INPUTS 1 and 2 Gain Trim Switch: In its +4 dBu position, the Input gain of the respective channel is unity. In the -10 dBV posi-
tion, the input gain is increased by 12 dB (although mathematically suspicious, it really is 12 dB, not 14 dB) to compensate for
certain recording devices. This switch must be in the +4 dBu position for front panel calibration accuracy.
OUTPUTS 1 and 2 are delivered by the balanced XLR or the unbalanced ¼" TS jacks. Using both types of Outputs are permissible
to drive two devices, such as an amplifier and a recorder. This device uses low impedance balanced line drivers. Do not connect the
XLR “+” or “–” output pins to ground, as this may cause the power supply to shut down. For unbalanced use, leave the unused output pin
(“+” or “–”) unterminated.
System wiring example for a DJ system
DC 22S STEREO COMPRESSOR
TTM 56S MIXER
AC 22S STEREO 2-WAY CROSSOVER
ME 15S STEREO EQUALIZER
OUTPUTS INPUTS
RIGHT LEFT
OUTPUTS
LEFT
INPUTS
RIGHT
LEFT RIGHT RIGHT LEFT
LEVEL LEVEL 0 10 0 10
LEVEL LEVEL 0 10 0 10
STEREO AMP, HIGH
MONO OR BRIDGED AMP, MONO SUB
RIGHT SPEAKER
LEFT SPEAKER
MONO SUBWOOFER
WIRING
TIP / PIN 2 = POSITIVE RING / PIN 3 = NEGATIVE SLEEVE = SIGNAL GROUND PIN 1 = CHASSIS GROUND
CHANNEL 1
OUTPUT INPUT
CHANNEL 2
OUTPUT INPUT MADE IN U.S.A. RANE CORP.
ME 15S
ACN 001 345 482
COMMERCIAL AUDIO EQUIPMENT 24TJ
R
100-240 V 50/60 Hz 7 WATTS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
ACN 001 345 482
INPUT
1
OUTPUT
1
BAL/UNBAL BALANCED BALANCED BAL/UNBAL
+4 dBu -10 dBV
MADE IN U.S.A. RANE CORP.
DC 22S WIRING 3-PIN XLR: • PIN 2 = (+), • PIN 3 = (–), • PIN 1 = CHASSIS (SHIELD)
1/4" PHONE, BALANCED: • TIP = (+), • RING = (–), • SLEEVE = CHASSIS (SHIELD)
1/4" PHONE, UNBALANCED: • SEE THE RANENOTE: SOUND SYSTEM INTERCONNECTION 100-240 V 50/60 Hz 7 WATTS
COMMERCIAL AUDIO EQUIPMENT 24TJ
R
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
INPUT
2
OUTPUT
2
BAL/UNBAL BALANCED BALANCED BAL/UNBAL
+4 dBu -10 dBV
ACN 001 345 482
LOW OUT CH 1 IN
3-WAY IN MONO SUB OUT MONO LOW OUT
HIGH OUT STEREO 2-WAY
SUBWOOFER SWITCH MUST BE SET TO 2- CHANNEL FOR MONO 3-WAY
CH 2 IN LOW OUT
2-CHANNEL SUBWOOFER MONO SUB
OMIT MONO MONO 3-WAY
MODE
OMIT MONO MONO SUB: OMIT MID OUT
HIGH OUT
HIGH OUT
MADE IN U.S.A. RANE CORP.
AC 22S
PIN 2: POSITIVE PIN 3: NEGATIVE PIN 1: CHASSIS GND
100-240 V 50/60 Hz 7 WATTS COMMERCIAL AUDIO EQUIPMENT 24TJ
R
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
AUX
PHONO GROUNDS
POWER PGM 1 PGM 2
4 3 2 1
4 4 3 3 2 2 1 1
4 3 2 1
100-240V 50/60 Hz 20 WATTS
ACN 001 345 482
MADE IN U.S.A. RANE CORP. U.S. PATENT 6,813,361
OUT IN
OUT IN
MIC
BALANCED
MASTER
OUTPUTS
R
L
R
L
R
L
R
L
R
L
R
L
LINE
PHONO
TTM 56S COMMERCIAL AUDIO EQUIPMENT 24TJ
R
EFFECTS SEND
UNBALANCED
FlexFX
RETURN
TIP = SEND RING = RTN BALANCED
ACN 001 345 482
INPUT
1
OUTPUT
1
BAL/UNBAL BALANCED BALANCED BAL/UNBAL
+4 dBu
-10 dBV
MADE IN U.S.A.
RANE CORP.
DC 22S WIRING
3-PIN XLR:
• PIN 2 = (+), • PIN 3 = (–),
• PIN 1 = CHASSIS (SHIELD)
1/4" PHONE, BALANCED:
• TIP = (+), • RING = (–),
• SLEEVE = CHASSIS (SHIELD)
1/4" PHONE, UNBALANCED:
• SEE THE RANENOTE: SOUND
SYSTEM INTERCONNECTION
100-240 V
50/60 Hz 7 WATTS
COMMERCIAL AUDIO
EQUIPMENT 24TJ
R
This device complies with Part
15 of the FCC Rules. Operation
is subject to the following two
conditions: (1) this device may
not cause harmful interference,
and (2) this device must accept
any interference received,
including interference that may
cause undesired operation.
INPUT
2
OUTPUT
2
BAL/UNBAL BALANCED BALANCED BAL/UNBAL
+4 dBu
-10 dBV