Citizen Systems iDP-3540 - Manual (Page 13)

iDP-3540/41 User’s Manual
CITIZEN 13/48
5-3. Parts Descriptions
(1) Power Cord Insert the plug end into an electric outlet.
(2) Power Switch Power is supplied to the printer by turning this switch on.
(3) Power Lamp This lights up when the power switch is “ON” and goes out
when turning “OFF”.
(4) SEL / ALARM Lamp This lights up when the printer is in SELECT state
(ON-LINE) and goes out when in DESELECT state (OFF-
LINE). The printer can print out the data only when this
lamp is on.
This lamp may blink on the following occasions.
a) When the paper roll in coming to near-end, the SEL / ALARM lamp keeps
blinking at interval of 1.0 second.
In this case, change the roll paper.
b)
When the printer is in alarm state, this lamp keeps blinking at interval of
1/4 second.
Remove the cause for alarm and press the SEL switch.
(or re-switch the power on)
(5) LF Switch Paper feeding is performed when this switch is pressed
(in DESELECT status only), this is used when inserting the
paper and for spacing up etc.
(6) SEL Switch When this switch is pressed, the printer enters SELECT
(ON-LINE) status. When pressed again, the printer enters
DESELECT (OFF-LINE) status.
This switch is also used when clearing an alarm condition.
And if this switch is pressed when printing, the printer
enters DESELECT status, after all the data in the buffer is
printed.
(7) I/F Connector Connects through a cable to a computer etc. Please be
certain that power to both the printer and the computer are
turned off when connection is made.
(8) Cash Drawer Connector To be used to control the P.O.S. cash drawer.
(9) Printer Cover Open when replacing the Ribbon Cassette.
(10) Manual Paper Feed Knob Use to adjust the paper position (Available only on pin
tractor paper feeding model).
(11) Rear Cover Cover for paper roll.
(12) Winder Connector Use Model CBM AW-3
(13) Stacker Basket for fan-fold paper.