Wilbur Curtis CBHT - Manual (Page 4)

4
Cold Brew Lock . . . (Factory set to 5º )
Press  to select, < or > to select desired setting (CBL 5, 15 or OFF), to set.
The Cold Brew Lock feature allows the brewer to brew at three different temperature levels from the actual set point. The first
setting is within 5 degrees of set point, next is within 15 degrees of set point, OFF is within 30 degrees of set point for the Ready
to Brew message, however, it will brew at any temperature.
Master Reset
Press  to display Are You Sure?
Then < for Yes, > for No. Brewer factory defaults are then reset.
Service Call (Phone number Factory set to 1-800-000-0000 X0000)
Press  to display number and change number or < to move place and EX to exit when complete. This number will be dis-
played during a Heating system SENSOR ERROR or during a WATER ERROR.
Access Code (Factory set to 1-2-3-4)
Press  to display number and change number, (the number can be changed 1 to 4) or < to move place and EX to exit when
complete.
Banner Name (Factory set to CURTIS)
Press  to display letters and change letters or < to move place and EX to exit when complete
This feature allows up to 14 letters to be programmed for company name or regional name. Programming all blanks disables
Banner Name. If programmed, Banner Name is displayed every 5 sec. on and off.
P-Maintenance (Factory set to OFF)
Press  to Select, Set gallons brewed to indicate P-Maintenance. Press < or > to adjust from Off to 9500 gallons. This feature
advances in 500 gallon increments. Press  to exit.
Beeper On/Off (Factory set to ON)
Press  to display ON or OFF. Pressing either < or > toggles between on and off.  to set. When ON, this feature allows you
to hear a short beep each time a button is pressed.
Coffee Drip-out Mode (Factory set to 2 minutes)
Press  to Select. Press < or > to move to desired time. Settings are OFF, 1, 2, 3, 4 and 5 minutes. Press  to Select time.
Tea Drip-out Mode (Factory set to OFF)
Press  to Select. Press < or > to move to desired time. Settings are OFF, 1, 2, 3, 4 and 5 minutes. Press  to Select time.
Displ. Brew Time (Factory set to ON)
Press  to display ON or OFF. Pressing either < or > toggles between on and off. After Display Brew Time an EXIT screen will
return you to Brew Button Prog.
Display Messages (Factory set to ON)
Press  to display ON or OFF. Pressing either < or > toggles between on and off. This feature allows the operator to select the
message “Rinse Server Before Brewing”. This will be displayed any time the unit is not brewing.
Brew Button Program
This is the next group of options in the sequence. The screen will prompt you to choose tea or coffee. Coffee options are shown
below. Tea option are shown on page 5.
Select Button This is a temporary screen message indicating you are in the coffee brew button programming mode. Select a
coffee brew button on the control module.
Brew by Volume (Factory settings: LARGE 200oz ±8oz. SMALL 64oz±4oz.)
Press  to Select. Display will ask you to select a brew button, Large, Medium or Small. Press the desired brew button to
begin... when desired volume is reached press the same brew button to stop the flow. Now the volume has been set.
Brew By Volume
Coffee
Drip-out Mode
Beeper On/Off
P-Maintenance
Banner Name
Access Code
Service Call
Master Reset
Cold Brew Lock
Displ. Brew Time
Tea
Drip-out Mode
Brew Button Prog
Select Button
Display Messages