Wilbur Curtis PTT3 - Manual (Page 4)

4
Programming
P-Maintenance
Beeper On/Off
Exit
Brew Count Odom.
Press  to Select, Shows total gallons and total brew cycles on the unit. Press ex or Reset Brew Count Total.
Brew Count Total
Press  to Select, Shows total gallons and total brew cycles on the unit. Cannot be reset.
Cold Brew Lock (Factory set to 5º F)
Press  to select, < or > to select desired setting (CBL 5, 15 or OFF), to set.
The Cold Brew Lock feature allows the brewer to brew at three different temperature levels from the actual set
point. The first setting is within 5 degrees of set point, next is within 15 degrees of set point, OFF is within 30
degrees of set point for the Ready to Brew message, however it will brew at any temperature.
Master Reset
Press  to display Are You Sure? Then < for Yes, > for No. When Master Reset is used, the all of the menu selec-
tions in the UCM return to factory defaults.
Service Call (Phone number Factory set to 1-800-000-0000)
Press  to display number and change number or < to move place and EX to exit when complete. This number will
be displayed during a Heating system SENSOR ERROR or during a WATER ERROR.
Access Code (Factory set to 1-2-3-4)
Press  to display number and change number, (the number can be changed 1 to 4) or < to move place and ex to
exit when complete.
Banner Name (Factory set to CURTIS)
Press  to display letters and change letters or < to move place and EX to exit when complete
This feature allows up to 14 letters to be programmed for company name or regional name. Programming all blanks
disables Banner Name. If programmed, Banner Name is displayed every 5 sec. on and off.
P-Maintenance (Factory set to OFF)
Press  to Select, Set gallons brewed to indicate P-Maintenance. Press < or > to adjust from Off to 3000 gallons.
Press  to exit.
Beeper On/Off (Factory set to ON)
Press  to display ON or OFF. Pressing either < or > toggles between on and off.  to set. When ON, this feature
allows you to hear a short beep each time a button is pressed.
Quality Timer (Factory set to OFF)
Press  to Select. By pressing < or > buttons, you can increase and decrease time. Setting range is from 0 to 10
hours in 1 hour increments. Press  to set. Expired time indicated by audio alarm and flashing “Quality Timer”.
Display Brew Time (Factory set to ON)
Press  to Select. Pressing < or > toggles between ON and OFF.
Display Messages (Factory set to ON)
Press  to display ON or OFF. Pressing either < or > toggles between on and off. This feature allows the operator to
select the message “Rinse Server Before Brewing”. This will be displayed any time the unit is not brewing.
Model Select (Factory set to 1/Half Batch)
Press  to Select. Pressing < or > toggles between 1/Half Batch and 3-Batch.
Exit
Press  to select, exits program mode and returns unit to operation. Pressing > returns you to Tea Recipes.
Quality Timer
Display Brew
Time
Banner Name
Model Select
Display Messages
Brew Count Odom
Master Reset
Service Call
Brew Count Total
Cold Brew Lock
Access Code