Wilbur Curtis PTT3 - Manual (Page 2)

2
SPRAYHEADS: Mentioned in this Programming guide are the words Gray and Purple. This refers to the color of the sprayhead. The current
sprayhead is the purple AFS. The older version is the gray sprayhead. See the illustration at right.
PURPLE
GRAY
To Go Into Programming
Turn off (dark display) by pressing ON/OFF button (yellow). Press and hold BREW button 4 (green) and then press and release ON/OFF button (yellow).
Continue holding BREW button. Display will read , wait until is displayed Enter the 4-digit access code, the digits 1-4 corre-
spond to the buttons (see illustration below).
The default code set at the factory is 1-2-3-4. Then will be displayed.
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
Scroll LEFT
 SELECTION or ENTER to save new parameter
Scroll RIGHT
4 3 1 2
BREWING INSTRUCTIONS
WARNING TO AVOID SCALDING, Do not remove the brewcone or coffee container until the UCM screen
indicates that the brew cycle has finished.
3. Place a new filter into the
brew basket. Pour leaf tea
into the brew cone.
4. Slide the tilled brew cone
into brew rails.
6. Select the desired BREW
button and press to start
brewing tea.
1. Brewer should be ON (Confirm at rear toggle switch, then press ON/OFF button). Ready-to-Brew should be dis-
played on the screen.
2. Make sure tea container is correctly placed on the brew deck, centered under the brewcone.