Wilbur Curtis D1000GT User Manual
Page 2
2
To Go Into Programming
Turn off (dark display) by pressing ON/OFF button (yellow). Press and hold BREW button (green), then press and release ON/OFF button.
Continue holding BREW button. Display will read
, wait until
is displayed Enter the 4-digit access code, the digits
1-4 correspond to the buttons (see illustration below).
The default code set at the factory is 1-2-3-4. Then
will be displayed.
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
Scroll LEFT
SELECTION or ENTER to save new parameter
Scroll RIGHT
Brewing Instructions
1. Brewer should be ON (Confirm at rear toggle switch, then press ON/OFF button). Ready to Brew on screen.
2. Open the lid on an empty airpot and place it on the brew deck. Be careful to center it under the brew cone.
3. Place a new filter into the brew cone.
6. Press the BREW button to
start brewing.
5. Position the brew cone
into brew rails.
4. Pour the proper amount
of ground coffee into the
brew cone.
WARNING HOT LIQUID, Scalding may occur. Avoid splashing.
To avoid temperature drop when first brewing coffee into the airpot, preheat the airpot with hot water.