Outdoor Great Room Crystal Fire - Manual (Page 8)

Page | 8 www.outdoorrooms.com Crystal Fire 42435 REV J 5.24.12
4
Setting up your Burner
A. Burner Assembly
 Check for damage. Do not use damaged components.
 The hose assembly must be replaced prior to the ap-
pliance being put into operation if there is evidence of
excessive abrasion or wear, or if the hose is damaged.
The replacement hose assembly specified by the man-
ufacturer.
 The burner must be replaced prior to the appliance
being put into operation if it is evident that the
burner is damaged. The replacement burner
assembly specified by the manufacturer.
 Position the assembly in the desired location. This loca-
tion must be adjacent to the gas supply line. You must
have easy access to the gas valve control knob after it
is installed and connected to the gas supply because
the ON/OFF gas valve is used to turn the burner on and
off.
 Make sure the tank valve is turned completely off
(clockwise).
 Ensure the tank valve has the proper external
mating
threads (tank valve marked “USE WITH TYPE
1”).
 Inspect the hose shipped with the appliance
for any
damage. Do not use if there is evidence of
damage.
 Connect the end of the hose onto the
ON/OFF gas
valve of the appliance. Make sure it is secured
tightly.
 Connect the regulator assembly to the tank valve.
Hand-tighten only (clockwise). Do not use a
wrench to tighten! Use of a wrench may damage
the quick closing nut and result in a hazardous
condition.
 Position the hose out of pathways where people
might trip over it or in areas where the hose
might be subject to accidental damage.
B. Glass Installation
Spread glass out evenly over burner area. Use all glass
provided for best affect. Keep glass clear of spark to
avoid accidental blockage.
Note:
A percentage of glass beads may arrive split in half.
This is normal. Additional beads may split after use.
This is also normal due to the physical properties of
glass.
DO NOT BURN WITHOUT GLASS OR
OTHER SUBSRATE SUCH AS LAVA
ROCK IN BURNER.