Nexen 5H60PSP-E 913059 - Manual (Page 10)

10
FORM NO. L-20205-C-1209
PARTS REPLACEMENT
DISASSEMBLY
Refer to Figures 2 & 3.
1. Remove Set Screws (Item 18 & 19).
2. Remove Retaining Ring (Item 14).
3. Fully supporting lip of Drive Flange Assembly (Item 10),
press Hub (Item 1), and Piston/Cylinder Assembly out
of Drive Flange Assembly.
4. Remove Rotary Seal (Item 4).
5. Remove Retaining Ring (Item 14).
6. Fully supporting Cylinder/Piston Assembly, press Hub
(Item 1) out of Cylinder/Piston Assembly.
7. Remove Compression Springs (Item 8) and Spring Pin
Stiffeners (Item 24).
SUPPORT SUPPORT
Piston/Cylinder
Assembly
Rotary Seal
(Item 4)
Drive Flange
Assembly
(Items 10 & 17)
Retaining Ring
(Item 14)
FIGURE 2
Spring Pin
Stiffener
(Item 24)
Cylinder/Piston
Assembly
Hub
(Item 1)
Spring
(Item 8)
FIGURE 3
Retaining
Ring
(Item 14)
BEARING REPLACEMENT (Item 12)
Drive Flange Assembly (Items 17 & 10)
Refer to Figure 4.
1. Remove Retaining Ring (Item 13).
2. Press Bearings (Item 12) out of Drive Flange Assembly
(Items 17 & 10).
3. Clean bore of Drive Flange with fresh safety solvent.
4. Apply Loctite ® 680 to O.D. of new Bearings, and press
new Bearings into Drive Flange Assembly (Item 17).
NOTE: When installing new Bearings, carefully align
Bearing O.D. with Drive Flange Bore to prevent
Bearing misalignment.
5. Install Retaining Ring (Item 13).
Retaining
Ring
(Item 13)
Bearings
(Item 12)
FIGURE 4
Drive Flange
Assembly
(Items 10 & 17)
CAUTION
Working with spring loaded or tension
loaded fasteners and devices can cause
injury. Wear safety glasses and take the
appropriate safety precautions.
CAUTION
Working with spring loaded or tension
loaded fasteners and devices can cause
injury. Wear safety glasses and take the
appropriate safety precautions.