beautypg.com

The bradford white – Bradford White UDH-75T-50FR-3N User Manual

Page 6

background image

The Bradford White

SERVICE PROCEDURE I

Inner Door/Gasket Removal, Inspection

Replacement and Reinstallation

6

Inner Door Removal Procedure

Step 1.

Rotate set point knob of the gas control to the “OFF” position.

Step 2.

Turn off the gas supply to the water heater

Step 3.

Remove the outer door.

Step 4.

Remove the four (4) ¼” hex drive screws holding the
right side inner door in place

Step 5.

Remove the three (3) ¼” hex drive screws holding the
left side burner door in place.

Step 6.

Disconnect the pilot tube from the gas control using a
7/16" wrench. Remove the main burner feedline from
the gas control with a ¾” wrench.

Step 7.

Disconnect the spark igniter wire from
the gas control.

Step 8.

Remove the burner assembly from the combustion chamber.

Step 9. Fully inspect burner and inner door gaskets for the following:

>Tears

>Other imperfections that will inhibit proper seal

>Missing Material

>Gasket adhesion to inner door

>Cracks

>Material left on combustion chamber (around opening)

>Dirt or debris

If the gasket is not affected by any of the above, gasket replacement is not required. If replacement is
required, proceed to Inner Door Gasket Replacement Procedure.

¼” Hex Drive Screws Right

Side Inner Door

¼” Hex Drive Screws at Flange

Area of Inner Door

¼” Hex Drive Screws on Left

Side Inner Door

6

This manual is related to the following products: