beautypg.com

The bradford white – Bradford White UDH-75T-50FR-3N User Manual

Page 18

background image

SERVICE PROCEDURE V

Gas Control

Testing, Disassembly & Replacement

GAS CONTROL DISASSEMBLY/REASSEMBLY

Step 11. Remove temperature sensor and insertion stick from backplate by first removing wire from the temperature sensor

wire routing clips located on the backplate. Note the orientation of insertion stick, insertion stick can only be

installed in one way.

Temperature sensor

wire routing clips

CAUTION

When reinstalling temperature sensor and insertion stick,
make sure the assembly is inserted FULLY into the
backplate and the wires are routed through the wire
routing clips. Failure to do so will not allow valve body to
be reinstalled properly and may damage temperature
sensor wires.

Insertion stick fully

inserted into backplate

Step 10. Remove the valve body by removing screw located at the lower left corner then unclipping the lower right side

from the backplate first followed by the lower left side using a flat head screwdriver.

Unclip lower left side

second

Unclip lower right

side first

CAUTION

Use caution not to bend or
damage valve body pins.

Valve body screw

18

The Bradford White

18

This manual is related to the following products: