beautypg.com

Bradford White TW-55X-78B-3X User Manual

Page 3

background image

Remove all components from the
package and check that all required
components are included. The required
components are: mixing device, cold
water tee, flexible metal connector and
thermostrip (see Figure 1).

This kit may have two flexible
connectors provided for water heaters
with top water course connections at 8
inch and 11 inch spacing. Use the
appropriate flexible metal connector.

The mixing device, cold water tee, flexible metal connector and thermostrip are integral parts of the
water heater. This system improves hot water deliverability and must be installed. The integrated
appliance is designed for a maximum working pressure of 150 p.s.i. (1034 kPa). Refer to the
“Water Connections” section of the installation and operation instruction manual supplied with the
water heater for additional instructions.

WATER CONNECTIONS

The mixing device is equipped with a ½” NPT alternate hot water
outlet that draws unmixed very hot water from the tank. This outlet
should be used if unmixed very hot water is needed at specific
fixtures (laundry, dishwasher, etc…). It is also equipped with a ½”
NPT optional recirculation inlet that must be utilized in conjunction
with a check valve if a recirculation loop is used (see Figure 2).

WARNING

If recirculation loop water is returned
to the water heater at any location
other than the optional recirculation
inlet, unmixed very hot hot water is
exposed to the recirculation loop.
Do not return recirculation loop to
any other location other than “R”
inlet of the mixing device.

Mixing
device

Flexible metal

connector

Cold water tee

Thermostrip

(AH) ½" NPT

Alternate hot

water outlet

(MIX) ¾" NPT

Mixed water

outlet

(COLD) Cold water

inlet from cold

water tee

(R) ½" NPT

Optional

recirculation inlet

(HOT) ¾" NPT Hot

water inlet from

water heater

Figure 1

IMD Components

Figure 2

Mixing Device

Page 3

Instructions