B&C Technologies EDG Dryer Control (DE, DP, DI Series) - Manual (Page 9)

Customizing the individual programs
The password required to access this phase is “955”. Proceed as follows : press keys UP and 1 at
the same time. At this point the message “PASSWO” appears on the display, then press ENTER.
The display now shows “00000”. Press three times the DOWN key to erase three zeroes starting
from the right, then type in the password “955”. Press ENTER. Actual programming starts now.
DISPLAY VALUES ALLOWED DESCRIPTION
Program selections through the UP and DOWN keys. The various configured programs are displayed.
Select the desired one by pressing ENTER.
LANGUAGE 0..7 Language:
0
English
1 Italian
2 French
3 German
4 Spanish
NAME 12 alphanumeric
characters Enter a new program name
This name is displayed when a program is selected by
pressing a numeric key, or when the machine turns on
again after a power failure occurred during program
execution. Press the DOWN key to erase the existing
text.
CYCLE TIME 0 .. max. value set in high
level programming Cycle time.
This field determines the duration of the drying program.
The value is expressed in minutes.
T ROTATION 10.. max. value set in high
level programming Rotation time (only if reversing is enabled)
Time in seconds the basket moves (both directions).
T PAUS min. value set in high level
programming... 250 Rotation pause time (only if reversing is enabled)
Time in seconds the basket stops between forward and
reverse.
° HEATING 30°C ... max. value set in
high level programming Heating temperature
Temperature to be maintained inside the basket during the
drying phase. In °C or °F, depending on the value entered
in field CEL SN in the operating ranges.
COOL TIME 0 .. max. value set in high
level programming Cool down time.
Duration (in minutes) of the cooling down phase at the
end of drying.
° COOLING 20 °C .. max. value set in
high level programming Cool down temperature
Temperature at which the cooling down phase ends after
the drying phase.
The value can be in °C or °F, depending on the value
entered in field CEL SN in high level programming
BUZZER 0 .. 15 (sec) Buzzer time.
Duration (in seconds) of the acoustic signal that indicates
program completion (end of the cooling down phase)
Programming
9