B&C Technologies EDG Dryer Control (DE, DP, DI Series) - Manual (Page 6)

opening the door or by pressing STOP once),
pressing this button will restart the program
exactly from where it left off ;
3. Dduring programming phases, pressing
this button allows to switch from one parameter
to the next.
In particular, when the name of a parameter is
displayed, pressing this key displays - and allows
to modify - the actual value of the parameter in
question. Once you’ve seen (or changed) the
value, pressing ENTER again allows to move on
to the next parameter.
If this does not happen after pressing ENTER, it
means that the new value is outside the allowed
range. In this case, you can correct the value or
cancel the change by pressing STOP and halting
the programming.
To select a program, press one of the 10
numerical keys found on the keyboard.
1. When you press one of these keys, the
name of the associated program will be displayed
(it will move across the screen since the max
length is 12 characters).
2. At this point, pressing START allows to
start the program. The program name disappears
and the current temperature in the drum along
with the time remaining until the end of the
program (residual time) will be displayed moving
across the screen.
When you press the SINGLE CYCLE key, you
will be asked to input the length of the drying
program and the desired temperature.
1. Press SINGLE CYCLE : the message
“CYCLE TIME” appears (requesting program
duration).
2. Press ENTER : the number “00000” is
displayed (default program duration expressed in
minutes).
3. Press DOWN to cancel the zeroes, starting
from the left, and then type in the desired
number of minutes.
4. Use the numerical keys to enter the
Program selection and execution
Single cycle
duration of the drying cycle.
5.
Press ENTER : if the number is within
the allowed range the message “HEAT”
appears (requesting the drying temperature).
6. Press ENTER : the number “00000”
appears (default temperature expressed in °F or
°C, depending on machine configuration).
7. Use the numerical and DOWN keys, as
in points 3 and 4, to set the desired
temperature.
8. Press ENTER to confirm the input
values. The message “PRESS START” is
displayed.
9. Press START to start the drying cycle.
Both the current basket temperature and the
time remaining until the end of the cycle are
displayed.
Operation
6