B&C Technologies EDG Dryer Control (DE, DP, DI Series) - Manual (Page 8)

Setting the operating ranges
The password required to access this phase is “916”. Proceed as follows : press both keys UP and
1 at the same time. The message “PASSWO” is now displayed, then press ENTER.
The display now shows “00000”. Press the DOWN key three times to erase three zeroes starting
from the right and then type in the password “916”. Press ENTER. Actual programming starts now.
DISPLAY ALLOWED VALUES DESCRIPTION
CELSIUS SN Yes/No Yes - Programs and displays in Celsius.
No - Programs and displays in Fahrenheit.
ANTICREASE
SN Yes/No Anti-creases. Enables or disables the anti-wrinkle feature at
the end of the program.
CYCLE TIME 0..99 (min) Cycle time.
This parameter specifies duration of the drying cycle.
T ROTATION 10..200 (sec) Rotation time (only if reversing is enabled).
This parameter indicates the maximum duration in seconds
of rotation entered in the programs.
T PAUS 10..250 (sec) Rotation pause time (only if reversing is enabled)
This parameter indicates the minimum time that the basket
must stop for between one motion reversal and the next.
° HEAT 30..99 (°C) Heating temperature.
Establishes the maximum temperature value that can be
programmed.
TIME COOL 0..15 (min) Cooldown time.
This parameter sets the maximum duration of the cool down
time for each individual program.
°COOLING 20..50 (°C) Cool down temperature.
The maximum temperature that can be set for each program
in order to consider cool down finished.
Programming
8