B&C Technologies IS Series Commercial Ironer - Manual (Page 25)

Figure 4.2: IS Series - Heat Control Panel
1. Heating Control Panel
2. Speed Control Panel
3. Exhaust
4. Compression roll release
5. Front Return table
4.1.1 Heat Control Panel
Control Panel Detail – refer to Figure 4.2 on page 22:
I GNITION – Indicates a call for heat
G AS V ALVE – Indicates the gas valve is open, and machine is heating.
F LAME S AFEGUARD – Will briefly illuminate upon call for heat. Continuous illumination indicates
ignition failure.
T EMPERATURE C ONTROL – Sets operating point of machine. Press the up arrow to increase the
operating temperature and the down arrow to decrease the operating temperature.
A LARM H IGH L IMIT – Safety thermostat has been activated. Check for proper operation of tem-
perature control.
22