Compaq uSign Signature Capture Module uSign 100 User Manual
User manual, Usign™ signature capture module
This manual is related to the following products:
Table of contents
Document Outline
- 1.0 Introduction
- 2.0 Features
- 3.0 Model Designations
- 4.0 Terms & Abbreviations
- 5.0 Installing uSign
- 6.0 Specifications
- 7.0 uSign commands description
- 7.1 Command protocol:
- 7.2 System Commands
- 7.3 One byte commands
- 7.3.1 Stop Capturing
- 7.3.2 Start Capturing use FBP format 1
- 7.3.3 Start Capturing use FBP format 2
- 7.3.4 Turn red led on
- 7.3.5 Turn red led off
- 7.3.6 Clear CMP format mode data
- 7.3.7 Get data 0x00
- 7.3.8 Start Capturing use CMP format
- 7.3.9 Reset points counter
- 7.3.10 Get point counter high byte
- 7.3.11 Get point counter low byte
- 7.3.12 Start Capturing use FBP format 0
- 7.4 Multi-byte commands
- 7.4.1 Initialize device
- 7.4.2 Get PW120 Version
- 7.4.3 Test device
- 7.4.4 Set CTS control
- 7.4.5 Set interval between two points
- 7.4.6 Get data 0x00 0x01
- 7.4.7 Calibrate the device
- 7.4.8 Set offset position
- 7.4.9 Get data 0x01
- 7.4.10 Offset using control
- 7.4.11 Stop Capturing
- 7.4.12 Start Capturing use FBP format 1
- 7.4.13 Clear display screen
- 7.4.14 Draw line
- 7.4.15 Draw hollow rectangle
- 7.4.16 Draw solid rectangle
- 7.4.17 Draw text