12 start capturing use fbp format 0, 4 multi-byte commands, 1 initialize device – Compaq uSign Signature Capture Module uSign 100 User Manual
Page 14: 2 get pw120 version, 3 test device, 4 set cts control, 5 set interval between two points, 6 get data 0x00 0x01, 7 calibrate the device, 8 set offset position
uSign User Manual
7.3
One byte commands
7.3.1 Stop
Capturing
Command string: C0
Response string: C0
7.3.2
Start Capturing use FBP format 1
Command string: C1
Response string: C1
7.3.3
Start Capturing use FBP format 2
Command string: C2
Response string: C2
7.3.4
Turn red led on
Command string: C3
Response string: C3
7.3.5
Turn red led off
Command string: C4
Response string: C4
7.3.6
Clear CMP format mode data
Command string: C5
Response string: C5
7.3.7
Get data 0x00
Command string: C6 or D4 or D5
Response string: 00
7.3.8
Start Capturing use CMP format
Command string: C7
Response string: C7
7.3.9
Reset points counter
Command string: D0
Response string: D0
7.3.10
Get point counter high byte
Command string: D1
Response string: D1
7.3.11
Get point counter low byte
Command string: D2
Response string: D2
Copyright © 2006, International Technologies & Systems Corp. All rights reserved.
Page 14 of 18