Dell C/Dock Expansion Station - Manual (Page 12)

While the C/Dock Expansion Station is still
npside-down, remove the fonr screws holding
the top case and bottom case together (see
Fignre 1-8).
Small arrows on the bottom case point to the proper
screws. Set aside the screws for use later in this
procedure.
Figure 1-8. Separating the Bottom Case and
the Top Case
9. Hold the top case and bottom case together with
yonr hand, and tnrn the C/Dock Expansion Sta­
tion right-side np and place it on a flat snrface.
10. Lift the top case np and away from the bottom
case (see Fignre 1-8).
Set aside the top case for use later in this procedure.
11. If necessary, remove the screws that anchor the
metal shield over the PCI expansion-card
assembly.
Set aside the screws for use later in this procedure.
12. Gently lift np the metal shield over the PCI
expansion-card assembly (Fignre 1-9). Take care
not to bend the small metal tabs on the shield.
13. Remove the screw on the monnting bracket
(see Fignre 1-9).
Set aside the screw for use later in this procedure.
14. Remove the empty monnting bracket. If a PCI
card is installed, remove it.
To remove the card, grasp the card by its outside cor­
ners, and ease it out of its connector.
15. Install a PCI expansion card.
Insert the card-edge connector of the card firmly into
the expansion-card connector (see Figure 1-9). Gen­
tly rock the card side-to-side into the connector until
it is fully seated.
Replace and tighten the screw on the mounting
bracket of the card.
16. Gently lower the metal shield. If yon removed
screws from the shield in step 11, replace them.
17. Reassemble the top and bottom assemblies.
Use the screws you removed in step 8. Start by
replacing the two screws next to the I/O panel.
18. Pnll the eject lever several times to make snre it
works properly.
1-8 Dell Latitude C/Dock Expansion Station User’s Guide