Canon DR-4010C - Manual (Page 26)

Chapter 2 Setup
2-11
2-4 Connecting the Scanner to the Computer
There are two methods for connecting the DR-4010C scanner to a computer: USB connection,
which makes use of a standard USB port on the computer, and SCSI connection, which makes use
of a SCSI card installed in an expansion slot of the computer. Select the method that is suitable for
your computer environment.
CAUTION
Do not connect a USB cable and SCSI cable at the same time.
Using a USB Connection
1
Verify that the power switch of the scanner is OFF.
If the power switch is in the ON position, push the switch to set it to OFF.
2
Plug the supplied power cord into the power connector on the back of the scanner. a
SCSI ID DIP Switches
USB Connector SCSI Connector
(half-pitch 50-pin, pin-type)
Power Connector
Power switch
OFF position ON position