Delete the old hibernate file – Dell Inspiron 5000e User Manual

Page 46

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ClHINT: Ifyou install

additional memory, you must

delete the original hibernate

file before recreating a new

one.

You must recreate the hibernate file if you perform any of the following

actions:

• Delete the hibernate file.
• Install a new hard drive.
• Reformat your hard drive.
• Install additional memory.

Boot (Restart) Your Computer With the

System Software

1 Save and close any open files, exit any open application programs, and

shut down the computer.

2 If the computer is connected to a port replicator, undock it (see

3 Turn on the computer.
4 Press when you see the Dell logo to access the system setup

program.

5 Press the right-arrow key to highlight Boot.
6 Press the down-arrow key to highlight a device, and then press or

to move the device up or down the list until they are in the

following sequence:

— Floppy
— CD ROM/DVD
— Internal Hard Drive

7 Insert the System Software CD into the CD or DVD drive.
8 Press to save your changes and exit the system setup program.

9 When the Setup Confirmation window appears, press to

confirm the configuration changes and exit the system setup program.
10 After the computer restarts and loads the diagnostic utility, press the

down-arrow key to select Exit to MS-DOS and then press .

Delete the Old Hibernate File

1 Boot your computer from the System Software CD as described the

preceding section.

4 ^ I S o l v i n g P r o b l e m s