Zippy GSM-7450P User Manual
Page 37
–
–
HG2, HP2, GSM and PSL
Ver. 2.0
- 37 -
INPUT CHARACTERISTICS:
PSL-6800P/PSL-6850P(G1)
VOLTAGE: 90 ~ 264 VAC FULL RANGE.
FREQUENCY: 47 ~ 63 Hz.
INPUT CURRENT: 13.5 A FOR 115 VAC, 6.0 A FOR 230 VAC.
INRUSH CURRENT: 75 A MAX. FOR 115 VAC, 150 A MAX. FOR 230 VAC.
OUTPUT CHARACTERISTICS:
LOAD LINE
RIPPLE & NOISE
MAX.[P-P]
5V
5%
1%
60mV
12V
5%
1%
120mV
5%
1%
120mV
5%
1%
120mV
3.3V
5%
1%
60mV
+5VSB
5%
1%
60mV
REMARK: +5V and +3.3V total power max: 250W.
TOTAL OUTPUT POWER SHOULD NOT EXCEED 700W FOR PSL-6701P.
*** WHEN PERFORMING CROSS REGULATION TEST, IT IS REQUESTED TO SET THE HIGHER OUTPUT
CHANNEL AT 90% MAXIMUM AND THE LOWER OUTPUT CHANNELS AT 20% MININUM OF RATED
SPEC.
TEMPERATURE RANGE: OPERATING 0
0
C --- 40
0
C, STORAGE –20
0
C --- 70
0
C.
HUMIDITY: 10 ~ 90 % RH.
HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & 90 VAC INPUT VOLTAGE.
DIELECTRIC WITHSTAND:
INPUT / OUTPUT 1500 VAC FOR 1 MINUTE,
INPUT TO FRAME GROUND 1500 VAC FOR 1 MINUTE.
EFFICIENCY: 71% TYPICAL, AT FULL LOAD, 115VAC.
POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms.
OVER LOAD PROTECTION: 110 ~ 160% MAX.
OVER VOLTAGE PROTECTION:
+5V
5.7V ~ 6.2V,+3.3V
3.7V ~ 4.1V,+12V
13.3 V~ 14.3V.
EMI: MEET FCC CLASS B, CISPR22 CLASS B.
SAFETY: UL 60950, TÜV TÜV EN-60950, CB CB IEC-60950:1999, CCC GB4943-2001, GB9254-1998,
GB17625.1-2003.
ACTIVE POWER FACTOR CORRECTION MEET IEC-1000-3-2 CLASS D
REMOTE ON / OFF CONTROL.
SHORT CIRCUIT PROTECTION: SHUTDOWN AND LATCH.
REMOTE SENSING ON 3.3 V DESIGN.
I
2
C FEATURES (OPTIONAL).
COOLING: ONE 80 mm DC BALL BEARING FAN.
DIMENSION: 86(H) X 150(W) X 220 (D) mm (STRETCH PS/2).