Specifications, Output characteristics, Specification – Zippy GSM-7450P User Manual
Page 20
–
–
HG2, HP2, GSM and PSL
Ver. 2.0
- 20 -
Specifications
Please refer to the specifications according to the actual product purchased.
Note: The new feature, “Prolonged Cooling” after power supply is remote-off only available on
model HG2. Under normal conditions, when power supply is at “Remote-off” mode, cooling fan
will remain in operation for the secondary heat dissipation, and will come to stop at a much
lower temperature. This will prolong the life of the power supply.
INPUT CHARACTERISTICS:
HG2-6400P(G1)
VOLTAGE: 90 ~ 240 VAC FULL RANGE.
FREQUENCY: 47 ~ 63 HZ.
INPUT CURRENT: 8.0 A (RMS) FOR 115VAC, 4.0 A (RMS) FOR 230VAC.
INRUSH CURRENT: 65A MAX. FOR 115 VAC, 125A MAX. FOR 230 VAC.
OUTPUT CHARACTERISTICS:
LOAD LINE
RIPPLE & NOISE
MAX.[P-P]
5V
5%
1%
50mV
12V
5%
1%
120mV
5%
1%
150mV
5%
1%
150mV
3.3V
5%
1%
50mV
+5VSB
5%
1%
50mV
REMARK: OUTPUT CURRENT OF+5V & +3.3V COMBINED SHOULD NOT EXCEED 45A.
SPECIFICATION:
TEMPERATURE RANGE: OPERATING 0
--- 40
HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE.
DIELECTRIC WITHSTANDING VOLTAGE:
PRIMARY TO SECONDARY : 3000VAC FOR 1 MIN.
PRIMARY TO FG : 2200VAC FOR 1 MIN.
EFFICIENCY: 70% TYPICAL.
POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms.
OVER LOAD PROTECTION: 130 +/- 20%.
OVER VOLTAGE PROTECTION:
+5V
5.7V ~ 6.5V, 3.3V
3.9V ~ 4.3V, 12V
13.6V ~ 15V.
SHORT CIRCUIT PROTECTION: +5V, -5V, +12V, -12V, +3.3V.
EMI NOISE FILTER: FCC CLASS B, CISPR22 CLASS B.
SAFETY: MEET UL 60950, CSA C 22.2 NO. 60950, TUV EN-60950,
CCC GB4943-1995/GB9254-1998/GB17625.1-1998
ACTIVE POWER FACTOR CORRECTION MEET IEC-1000-3-2 CLASS D
REMOTE ON / OFF CONTROL.
THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE / ENABLE
ALL OUTPUT VOLTAGES (EXCLUDE +5V STANDBY),
AS LOGIC LEVEL IS LOW, OUTPUT VOLTAGES WERE ENABLE,
AS LOGIC LEVEL IS HIGH, OUTPUT VOLTAGES WERE DISABLE
ADVANCED THERMAL & ACOUSTICS CONTROL FEATURES..
3.3V / 5V REMOTE SENSING.
COOLING: ONE 80mm DC BALL BEARING FAN.
DIMENSION: 140 (D) x150 (W) x 86 (H) mm (PS/2).