Xpres Gem Tec - Manual (Page 4)

R-Wear Setup
Run R-wear, now click on
File>Preferences. In the above
window change the Currency to
GBP.
Engraving fonts are available to
download from
www.xpres.co.uk/techsupport
Now click on File>Output Device
Setup. Set the Printer option to the
relevant cutter, in this case the
‘Roland GX-24' as shown above.
Click OK to confirm. Click on the Rhinestone button
along the top property bar. The
Rhinestone window docker will
appear. Now click Edit Stone
Library (shown in
) to reveal the
add/remove rhinestone window as
shown (
red
blue ).
We now need to create two new Rhinestone options. To do this select any
rhinestone from the list and click Copy as shown in
red
red
(diagram 1).
Now edit the areas shown in - These settings should be as follows:
Name & colour: ‘1. GemTec SS10'. (change the colour option to ).
Change the Diameter: ‘3.2'.
Change the Size: ’SS10'
Change the Cost: ‘0.002'
blue
.
.
Now click Copy once more to create the second new rhinestone (as shown
in diagram 2). Repeat the same steps as before with the following settings:
Name & colour: ‘1. GemTec SS16'. (change the colour option to
).
Change the Diameter: ‘4.2'.
Change the Size: ’SS16'.
Change the Cost: ‘0.003'.
Now click OK to confirm the setting.
red
Diagram 1 Diagram 2
Now close down R-wear and re-
open the software. You should now
see that the two rhinestone options
previously created show at the top
of the Rhinestone window/docker
as shown in the above image.
R-wear is now fully set up and
ready to use.
? When setting the Rhinestones options we use SS10 and SS16 as this represents the size of the
Rhinestones. SS10 and SS16 are industry recognised as 3mm and 4mm Rhinestones.
? We set the Diameter to 0.2mm bigger than the Rhinestone size as this helps in the process when
placing the Rhinestones into position using the stencil.
2