beautypg.com

Doming – Xpres Easy Dome User Manual

Page 7

background image

Using Flame Gun

If there are any air bubbles in the resin, the Flame Gun should be used. Position the flame gun approximately 3-6 inches away
from the surface of the resin and momentarily pull the trigger. The short blast of heat will cause the air bubbles to heat up and
rise out of the resin.

What to do if the resin over-spills?

If the resin over-spills over the edge of the transfers, you can correct small errors using the supplied Repair stick. It is
recommended to let the Xpres easy Dome Resin cure for approximately 10 - 15 minutes before correcting over-spills.
This allows resin to ‘gel’ as the curing process begins, which will make any corrections much easier.
With the supplied Repair stick (you may wish to break this in to two pieces, length ways to give you a point) you can scoop
or drag the excess resin back on to the transfer. You can then run the Repair stick around the edge of the transfer to prevent
further over-spill.

7

Doming

Before

After