Workrite Willow Dual Assembly Instructions - Manual (Page 4)

4 Workrite Ergonomics 800.959.9675 www.workriteergo.com
Cable Management
4
Upper arm: Insert cables into the recessed area under the
upper arm by spreading the clips apart.
a
Lower arm: Pull cover off the underside of the extension, place
cables into recess, then snap cover back on.
b
a
b
Desk Base: If using the Grommet
Mount, you can thread cables
into the grommet hole using the
indentation in the base.
c
c
5
Adjust the Monitor Tilt Action
Depending on the size of your monitor, it may be necessary to adjust
the tilt setting.
If the monitor doesn’t hold its tilt position or is too hard to tilt, adjust
the screw directly behind the monitor on the side of the arm. Use
the 3 /
16
" Allen Wrench (H) (clockwise to tighten, counter-clockwise to
loosen). Check the monitor, and adjust again as necessary.
Adjust the Monitor Vertical Movement
The Willow Arm is preset to balance a 6-pound monitor. If your monitor weighs more or less than
this, it may be necessary to adjust the friction of the arm. Test the friction by raising the arm all
the way up, waiting to see if it moves, and then lowering the arm all the way down. If the arm
drops from the top or rises off the bottom, you will need to adjust the friction.
Use the 3 /
16
" Allen Wrench (H) to make small adjustments in the arm friction by turning the
screws in each end of the upper arm. Always turn both screws the same amount in small steps,
until the arm no longer rises or falls. Do not overtighten or the arm will be too stiff to make easy
adjustments in monitor position.
Friction Adjustment
Tilt Adjustment Screw
6
H
H
Grommet mount only
pull
off
snap
back
Adjust both screws in small, equal steps
To increase friction turn screw clockwise
To decrease friction turn screw counter-clockwise
!