Workrite Willow Dual-Wide Assembly Instructions User Manual

Page 3

Workrite Ergonomics 800.959.9675 www.workriteergo.com

Attach Monitors

Quick Release Option:

Attach the Quick Release Bracket (B) to the VESA mount holes on your monitor. Use the screws

from your monitor if possible. The tab on the bracket should be on the bottom.

For Recessed Mounts:

For monitors with recessed mount where the

Quick Release Bracket will not fit into the

mounting location,10mm Plastic Spacers (F)

have been supplied. Install these between

the monitor and the Quick Release Bracket as
shown with the shortest M4 screws possible.

Attach the Willow Arm to the monitor by sliding

the Quick Release Bracket over the mounting

plate.

Note: Your Quick Release Bracket has

convenient storage on its sides for the

Allen Wrench (H).

Important Note

It is strongly recommended to use the mounting screws provided by the monitor

manufacturer if possible. If longer screws are needed, use either part (C) 18mm long,

(D) 12mm long, or (E) 8mm long. NOTE: Always use the shortest screws possible to

avoid damage to the monitor.

Direct/Secure Mount Option:

Attach the Willow Arm VESA mount to the

VESA mount holes on your monitor. Use the

screws from your monitor if possible. The

clip on the bracket should be on the bottom.

For Recessed Mounts:

For monitors with recessed area where the

VESA mount will not fit into the mounting

location,10mm Plastic Spacers (F) have been

supplied. Install these between the monitor

and the VESA mount as shown with the
shortest M4 screws possible.

Note: Keep your Quick Release Bracket (B)

for possible future use.

Use (F) for

recessed

mounts only

Tab on bottom

Use (F) for

recessed

mounts only